Heating Maintenance
Regular heating maintenance ensures safety, cost savings, and warranty compliance while improving energy efficiency and indoor air quality. It helps maintain the system’s lifespan and prevent costly breakdowns. Up to 30% of repairs can be prevented and you can achieve up to 85% in energy savings with routine upkeep.
During your annual heating maintenance, our technicians will complete the following tasks to ensure your system is running safely and efficiently.
- Verify Thermostat Operation: Ensure proper functioning and replace batteries if necessary.
- Clean/Check Air Filter: Clean or replace the air filter to maintain good airflow.
- Inspect Blower Motor: Check for proper operation and efficiency.
- Mechanical Room Safety Inspection: Inspect the area around your equipment for safety hazards.
- Check for Gas Leaks: Ensure no gas is leaking from your system for safe operation.
- Inspect Furnace Heat Exchanger: Check for any signs of cracks or wear.
- Inspect/Clean Burners: Clean burners to ensure efficient combustion.
- Inspect/Clean Flame Sensor: Ensure the flame sensor is clean and working properly.
- Inspect/Test Ignition System: Verify the ignition system is starting the furnace correctly.
- Verify/Adjust Gas Pressure: Ensure gas pressure is within safe and efficient limits.
- Inspect Combustion Air Hood: Make sure the combustion air intake is clear.
- Inspect Electrical Connections: Check all electrical components for safety and reliability.
- Inspect Electrical Connections: Check all electrical components for safety and reliability.
- Inspect Safety Components: Test safety switches and other components to ensure proper function.
- Inspect Induced Draft Motor/Vent Piping: Verify the draft motor and vent piping are working properly.
- Inspect/Clean Drain System: Clean and inspect the drainage system for clogs or leaks.
- Inspect Accessories: Check and service accessories such as humidifiers, UV systems, and HEPA systems.
- Inspect/Test Zone System (if applicable): Ensure proper operation of any zoned heating systems.
- Inspect Air Exchanger (if applicable): Check the air exchanger for proper ventilation.
- Test/Measure Combustion Levels: Ensure safe and efficient combustion.
- Verify Temperature Rise: Measure temperature rise to confirm proper heating.
- Inspect Ductwork for Cleanliness: Check ducts for any buildup that could affect airflow.
- Test Cycle Unit: Run a full heating cycle to verify proper operation of the system.
*Results may vary
On Time Service Pros
15191 Boulder Court, Rosemount, MN 55068 | Privacy Policy | Terms & Conditions
© 2024 On Time Service Pros. All Rights Reserved | Website Design by TMD MKTG