Cooling Maintenance
Routine cooling maintenance promotes safety, reduces costs, and keeps your warranty intact while enhancing energy efficiency and air quality. It extends the lifespan of your system and helps avoid expensive breakdowns. By staying on top of regular upkeep, you can prevent up to 30% of repairs and potentially save up to 85% on energy usage.
During your annual cooling maintenance, our technicians will complete the following tasks to ensure your system is running safely and efficiently.
- Wash Condenser Coil and Outdoor Unit: Keeps the unit efficient by improving heat transfer and reducing wear.
- Remove Leaves and Debris from Outdoor Unit: Prevents airflow blockages and damage to the unit.
- Verify Thermostat Operation and Replace Batteries: Ensures proper system control and avoids breakdowns.
- Check Refrigerant Charge: Ensures efficient cooling and prevents compressor damage.
- Measure Temperature Drop Across the Evaporator Coil: Confirms proper cooling and identifies potential issues.
- Clean or Replace Air Filter: Improves airflow, air quality, and system performance.
- Inspect Blower Motor: Ensures efficient air circulation and prevents early failures.
- Perform Mechanical Room Safety Inspection: Prevents hazards around the equipment.
- Check for Gas Leaks: Protects against dangerous leaks and carbon monoxide.
- Inspect Furnace Heat Exchanger: Prevents carbon monoxide leaks by checking for cracks.
- Inspect Ductwork for Cleanliness: Improves airflow and air quality.
- Inspect Air Exchanger (if applicable): Ensures proper ventilation and fresh air intake.
- Inspect Evaporator Coil: Ensures efficient cooling and prevents freeze-ups.
- Check and Clean Condensate Drain: Prevents water damage and system shutdowns.
- Inspect Electrical Disconnect Box and Wiring: Ensures safe and reliable electrical operation.
- Tighten Electrical Connections: Prevents overheating and electrical failures.
- Inspect Compressor: Maintains system cooling and avoids costly repairs.
- Inspect Start and Run Capacitors: Ensures smooth system starts and operation.
- Inspect Contactor: Prevents short-cycling or system failure.
- Measure AMP Draw on Compressor and Motor: Confirms electrical efficiency and detects potential problems.
*Results may vary
On Time Service Pros
15191 Boulder Court, Rosemount, MN 55068 | Privacy Policy | Terms & Conditions
© 2024 On Time Service Pros. All Rights Reserved | Website Design by TMD MKTG